Include

[SLACkra]

The center dividing blade looks to finish flush with the front so it will need to be cut back to allow for application of sliding doors

once i do get the sliding door pannels and glass i would see how much more it will need to be cut back and cut it back acordingly.

Exposed edges can be finished in preglued edgetape (available in rolls ) and ironed on to activate the glue.

will look into this if nessesary.

A base rail is a good idea to prevent substrate clogging up the sliding door track but must be thick enough to mount the base track on top.

actually it will be more like glass sliding doors then inside of the cage a edge bit to hold substrate in etc.

Ps it is difficult to tell if your cabinet is constructed of HMR (high moisture resistent) but it is a good idea to seal any exposed mdf as it is usually bonded using urea formaldehyde which isnt good for your snakes.

ok no exposed MDF in the enclosure, can do that.

also little update! got my heat mat, dual location thermomter and t-shirt from the herpshop. testing everything out atm. and if trader or her hubby read this i will be sending out the cheque tommorow

going to pickup a 2ft tank asap, preferably a 2ft x 12 x 16 as a 20g would make a better fish tank!(more room for a deep sand bed! i so wana upgrade my salty!)

cheers

andrew

ok set up everything on the click clack to see if it all worked. got the warm side of the click clack at about 26'C and the cold at 20'C. i am happy to say everything is working properly!

andrew