Quote:
Originally Posted by symbol  Gday folk
I have attached a design of my proposed enclosure with all the measurements.
They will be four individual boxes. Not one big enclosure.
The high one (about 1200 is for a diamond. The long one on the bottom (about 1400) will be for a BHP that i am getting. The other two are for hopefully for a stimmi and childreni or a small variety.
Could you tell me your honest thoughts on my plan before I get it built?
Are the enclosures big enough for what I want, espeically the BHP on the bottom.
Hope its clear enough. |
OK ill be honest
You will waste alot of wood building this ( it will be expensive)
You should make the depth 595 that will save you a bit
Square boxes are a pain to heat (Trust me the first few i made were nearly square Never again)
If you make the overall lenth 1200 you will save heaps in wood.
Square boxes are a pain to heat (Trust me the first few i made were nearly square Never again)
and make the 2 square boxes 400 high you will get 1 extra enclosure and it will be easier to heat.
a 1200 x 600 x 600 is big enough for a BHP.
if you make the bhp enclosue to a hight of 450mm or 500mm rather than the 600 you were talking
You could make the dimond a bit higher and the 3 stimmie ect enclosures a bit higher.
Or just make it that much smaller
All this means nothing if you are making it to fit a whole wall or something.
But im sure you will do what you like.
Regards Craig
Valley Reptile Supplies
