enclosure for a stimson or spotted
- Thread starter jezza11
- Start date
Help Support Aussie Pythons & Snakes Forum:
- Status
MSD Reptiles
Active Member
Ive been noticing the 'NO LINKS PLEASE' popping up a bit in the last few days. Is there a new site rule or thread relating to that which i have missed?
Or is it just in reference to rule 5 of the Advertising rules? Site Rules - Aussie Pythons & Snakes If so, i assume this link linked straight to a businesses product hence the breach???
Or is it just in reference to rule 5 of the Advertising rules? Site Rules - Aussie Pythons & Snakes If so, i assume this link linked straight to a businesses product hence the breach???
BRAND NEW Medium Enclosure Size - 900mm x 400mm x 400mm when assembled
All the below is included, all you need is a drill, a small & medium drill bit and approximately 30 minutes and you’ll have a great looking reptile enclosure!
· Easy to understand, coloured & step by step, instructions
· 7 pieces of white, pre drilled, melamine wood sealed on each side that is visible once put together
· 1 air vent (pre cut hole in the back of the enclosure)
· 30 screws for screwing the enclosure together
· 4 smaller screws to screw the air vent in
· 2 plastic glass runners
· Super glue to fix on the glass runners
· 2 pieces of glass for the front of your enclosure
· 22 white screw caps to finish off a neat look (8 less than the screws as not needed on the bottom of the enclosure)
(does not include light fittings or thermostat)
is that ok thats the info of the enclosure
also would thses measurements be suitable as well [FONT=Arial, Helvetica, sans-serif]600mm x 400mm x 400mm[/FONT]
All the below is included, all you need is a drill, a small & medium drill bit and approximately 30 minutes and you’ll have a great looking reptile enclosure!
· Easy to understand, coloured & step by step, instructions
· 7 pieces of white, pre drilled, melamine wood sealed on each side that is visible once put together
· 1 air vent (pre cut hole in the back of the enclosure)
· 30 screws for screwing the enclosure together
· 4 smaller screws to screw the air vent in
· 2 plastic glass runners
· Super glue to fix on the glass runners
· 2 pieces of glass for the front of your enclosure
· 22 white screw caps to finish off a neat look (8 less than the screws as not needed on the bottom of the enclosure)
(does not include light fittings or thermostat)
is that ok thats the info of the enclosure
also would thses measurements be suitable as well [FONT=Arial, Helvetica, sans-serif]600mm x 400mm x 400mm[/FONT]
striker321
Active Member
wow, how much is that?
- Status
