Hi all,
Later on this year i was planning on building some outdoor aviaries/cages in school (it's an Ag school, so there is a very good metalwork setup).
The aviaries/cages would most likely be suited for my future herps such as adult ridge tailed monitors (ackies) or adult carpet pythons.
I have looked at different designs and am curious as to what size mesh schould be used, e.g. wire thickness, width of spacings etc and also how you attached it to the cage, e.g. tack weld, cable tie etc
I understand the concepts of the design such as frame structure but the specefics i'm curious about.
It would be greatly appreciated if you could give me any tips or post your designs and explain the steps and materials you used.
Cheers,
David
Later on this year i was planning on building some outdoor aviaries/cages in school (it's an Ag school, so there is a very good metalwork setup).
The aviaries/cages would most likely be suited for my future herps such as adult ridge tailed monitors (ackies) or adult carpet pythons.
I have looked at different designs and am curious as to what size mesh schould be used, e.g. wire thickness, width of spacings etc and also how you attached it to the cage, e.g. tack weld, cable tie etc
I understand the concepts of the design such as frame structure but the specefics i'm curious about.
It would be greatly appreciated if you could give me any tips or post your designs and explain the steps and materials you used.
Cheers,
David
Last edited: