Lockie_1
Not so new Member
Hey guys I was wondering if anyone has used the 4" ceramic screw in E27 light fittings? If so how did you make your backing plates? I only made a couple using 19mm
Thick pine with a channel in the middle routed into it, then I used a hole saw to cut them out however with a hand held drill it's not the neatest way to do it. But I guess you can just perfect them by hand but I was just wondering if anyone else had any other ideas?
Thick pine with a channel in the middle routed into it, then I used a hole saw to cut them out however with a hand held drill it's not the neatest way to do it. But I guess you can just perfect them by hand but I was just wondering if anyone else had any other ideas?