Bar Fridge Incubator - Calic/Denver 2012 Project

Aussie Pythons & Snakes Forum

Help Support Aussie Pythons & Snakes Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Status
Not open for further replies.
I'd also like to know where you got that thermostat. Looks fancy.
 
I'm also using a fridge for my incubator, however I'm using a 50w heat cord threaded through 10mm corflute then run diagonally across the rear for heat. Would the fans not blow heat on one spot as opposed to the heat cord heating much more evenly?
I like to use multiple smaller wattage cords rather than one larger wattage cord so the all your eggs are not in the same basket so the risk of failure is spread. I use 4 x 25 watt cords plugged into a power board , then the thermostat, in a three door coke fridge.
 
I like to use multiple smaller wattage cords rather than one larger wattage cord so the all your eggs are not in the same basket so the risk of failure is spread. I use 4 x 25 watt cords plugged into a power board , then the thermostat, in a three door coke fridge.
That's smart, hope you didn't have to learn that the hard way!
 
Here is a pic for you to indicate the size of the eggs compared to a 600ml of water. Hope this helps you with choosing a tub.
Regards,
T

JX9A2236.jpg
 
Status
Not open for further replies.
Back
Top