iamwilso
Not so new Member
Hey guys just wondered if anyone has any tip's for getting a cleaner cut while cutting malemine? I'm using a circular saw as I don't have access to a table saw or any other fancy tools.
A sharp saw blade with a lot of teeth as opposed to a rip blade. fast speed and a slow push through the melamine. I have heard taping the line you are going to cut can help.
Lol funnycut a few mill away from the line and plane it back to the line.
Mine cost me $50 ... Use masking tape with minimal chipping and I cut so the slightly chipped side is the inside of my enclosures which I fully seal with white silicone
Works fine for me mate... Once sterilised always wash down with water.... Jeeez can't plz anyone these daysLOl still chips but doesn't it! And silicon has a life span, a couple of years down the track with f10 and cleaning products the silicon comes away and the chipped bits let in moisture.
Enter your email address to join: