I use the B1ME thermostat with a heat mat to regulate the temp of my click clack. Was wondering if anyone else finds that it seems innacurate? I have a probe thermometer set up as well, and the two probes are close to one another so should read the same temperature.
But, I have to set the thermostat to a few degrees lower than the temperature displayed by the thermometer. Lately it has been even worse and no matter what I do the thermometer seems to always creep up to around 34degrees even with the stat set to 27. It's as though the thermostat isn't doing anything at all and the heat mat is just constantly heating.
Anyone else had this problem or knows what I might be doing wrong? I'm not sure whether I should trust the thermometer or the thermostat to give a more accurate 'reading'.
But, I have to set the thermostat to a few degrees lower than the temperature displayed by the thermometer. Lately it has been even worse and no matter what I do the thermometer seems to always creep up to around 34degrees even with the stat set to 27. It's as though the thermostat isn't doing anything at all and the heat mat is just constantly heating.
Anyone else had this problem or knows what I might be doing wrong? I'm not sure whether I should trust the thermometer or the thermostat to give a more accurate 'reading'.